Wasp-barcode WLS9600 Product Reference Guide Manual de usuario descargar pdf (Pagina 250)

References

240

WLS9600

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one character and the

beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in

10ms increments. A setting of zero specifies no delay.

This feature applies ONLY to the Keyboard Wedge interface.

To set the delay:

1. Determine the desired setting in milliseconds.

2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead-

ing zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.

3. Go to page 41 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter

Programming Mode.

4. Scan the barcode: SELECT INTERCHARACTER DELAY SETTING.

5. Scan the appropriate two digits from the keypad in Appendix D, Keypad, that represent

the duration which was determined in the steps above. You will hear a two-beep indica-

tion after the last character.

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the begin-

ning.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming

Mode.

This completes the procedure. See Table 36 for some examples of how to set this feature.

Table 36. Intercharacter Delay Setting Examples

STEP ACTION EXAMPLES

1 Desired Setting

50ms 150ms 600ms 850ms

Divide by 10 (and pad with

leading zer

oes to yield two-

digits)

05 15 60 85

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT INTERCHARACTER DELAY SETTING

Scan Two Characters From

Appendix D, Keypad

‘0’ and ‘5’ ‘1’ and ‘5’ ‘6’ and ‘0’ ‘8’ and ‘5’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 245 246 247 248 249 250 251 252 253 254 255 ... 305 306

Sin comentarios

Wasp-barcode WLS9600 Product Reference Guide Manual de usuario Pagina 250