Wasp-barcode HD300 Manual de usuario descargar pdf

BC100/RF200/HD300 Clock Mounting Instructions

866.547.9277

www.waspbarcode.com

Box Contents:

1 BC100, RF200 or HD300 Clock

1 Power Supply Cord

1 Network Cable

4 Screws

4 Wall Anchors

2 Clock Screws (small black screws)

1 Metal Mounting Plate

Included Parts:

Tools Needed:

pencil, level, drill, 1/4inch drill bit, hammer, Philips head screw driver.

Clock Installation

Before mounting the clock on the wall consider the location of available power and Ethernet connections.

1. Remove the clock from the box and from the plastic wrapping.

2. Draw a level line on the wall where you want the clock to be (3’10” above the floor is about the

same height as light switches).

3. Hold the mounting bracket to the wall and drill four holes in the appropriate positions in the

bracket.

4. Hammer a wall anchor into each of the holes until they are flush with the wall.

5. While holding the mounting bracket in position, tighten a mounting screw into each of the anchors

6. Plug the network cable or RS232 cable and power cable into the clock. Guide the cords through

the cord spaces on the back of the clock.

7. Place the clock carefully on the mounting bracket. Screw one of the small black clock screws into

the hole in the bottom of the clock.

Wall Mount Screws

and Anchors

Clock Screws

Pagina 1

BC100/RF200/HD300 Clock Mounting Instructions 866.547.9277 www.waspbarcode.com Box Contents: 1 BC100, RF200 or HD300 Clock 1 Power Supply Cord

Modelos relacionados RF200 | BC100 |

Sin comentarios